KPI-JCI 8036-30

MAIN TANK
– 1/4” welded plate steel construction with angle and
channel iron reinforcement
– 4” rising current inlet
– Large (nominal 11” square) tank drain/clean-out ports
– Overflow discharge ports with adjustable level weir
boards on each side of the unit

SPIRAL ASSEMBLY
– Spiral pipe - heavy wall 14” dia.
– Cast steel paddle brackets
– 12-3/16” L x 10-1/2” W x 1-3/4” T cast two piece
Ni-Hard paddle tips with corrugated face
– Reverse involution paddle configuration (see reverse side
for additional information)
– Greaseable, externally mounted Dodge Imperial E tail
end flange bearing
– Head end support via the gear box
– Lower end seal - chrome plated stainless steel wear
sleeve, water tight bellows type rubber seal and
secondary grease seal

DRIVE ASSEMBLY
– High efficiency v-belt drive assembly
– 100 HP TEFC motor
– Custom engineered single input dual output double reduction gearbox
    Unground helical gears with an AGMA Surface
    Durability Service Factor of 2.62 @ 100 HP and 33 rpm
    Gearbox bearings are Timken tapered roller bearings

 BOTTOM CLEAN-OUT PORTS (optional)
– 24” x 24” clean-out ports located along the bottom of the
tub

SUPPORT ASSEMBLY (optional)
– Skid assembly with support locations for operation at 6o, 8o, or 10o

PHYSICAL/OPERATING CHARACTERISTICS
– Feed Material Size - 4” max. x 3/8” or #4 mesh min.
– Angle of Operation - adjustable (6o, 8o, or 10o)
– Capacity - 85 - 200 TPH
– Shaft Speed - 33 rpm
– Water Requirements - 50 - 500 gpm
– Operational Dim. @ 8o Angle of Operation - 35’2” long
    x 7’4” wide x 12’3” high (with optional support assembly)
– Loads - Approx. Dead Load = 34,000 lbs. support not included
   Approx. Live Load = 45,000 lbs. support not included
   Approx. Total Load = 79,000 lbs. support not included