KPI-JCI 6024-15S

MAIN TANK
– 3/16” (sides & bottom) and 3/8” (rear end plate) welded
plate steel construction
– Integral rising current manifold with 4” inlet
– Long narrow tub
– Full width overflow weir
– Overflow flume with 6” dia. outlet

SPIRAL ASSEMBLY
– Spiral pipe - heavy wall 8” dia.
– Double pitch, combination flight/paddle configuration
– Standard configuration - Four (4) bolt-on paddle assemblies (two (2) replaceable Ni-Hard paddle tips per
assembly) and two (2) bolt-on flight assemblies; balance of the spiral assembly is welded solid flights with bolt-on
Ni-Hard wear shoes (see reverse side for additional information and optional configurations)
– Greaseable, externally mounted Dodge Imperial E tail end flange bearing
– Greaseable Dodge Type E pillow block head end bearing
– Lower end seal - chrome plated stainless steel wear sleeve, water tight bellows type rubber seal and
secondary grease seal

DRIVE ASSEMBLY
– High efficiency v-belt drive assembly
– 15-HP TEFC motor
– Dodge TA-II double reduction shaft mount reducer

DISCHARGE CHUTE (optional)
– Tapered discharge chute set at 45° angle to grade

SUPPORT ASSEMBLY (optional)
– Head-end support weldment with 6” wide flange
columns

PHYSICAL/OPERATING CHARACTERISTICS
– Feed Material Size - Typically minus 2-1/2” x +3/8”
– Angle of Operation - 15°
– Capacity - Up to 75 TPH
– Shaft Speed - 40 rpm
– Water Requirements - Up to 400 gpm
– Operational Dim. - 18’6” long x 3’3” wide x 8’6” high
– Loads - Approx. Dead Load = 6,200 lbs.
Approx. Live Load = 9,000 lbs.
Approx. Total Load = 15,200 lbs