Fields with asterisks* are required. Your friend will receive an email that contains a reference to this page. Please send this email only to people you know who would be interested in this information.
SCREEN KPI-JCI 6’ x 20’, 3-deck, 10o, wet vibrating screen – V-belt drive assembly with 40-HP, 1800 RPM motor – Huck-bolted assembly – 3/8” plate steel side plates – Two (2) 160-mm bearings – Eccentric shaft with bolt-in counterweights – Eight (8) coil spring suspension system – Side tension drawbar screen cloth retention system (screen cloth is optional) – Screen operates at 10o angle with a shaft speed of approx. 900 rpm
FINE MATERIAL WASHER KPI-JCI Model 5044-32T (44” twin) fine material washer – Tank is of 1/4” (sides and bottom) and 3/8” (rear end plate) welded plate steel construction and includes a curved bottom with integral rising current manifold (4” dia. inlet) – Large undisturbed pool area with adjustable weir boards and overflow flume with 12” dia outlet – Double pitch, solid flight spiral assembly with standard AR steel inner wear shoes and standard urethane outer wear shoes – Greaseable, externally mounted Dodge Imperial E tail end flange bearing; greaseable Dodge pillow block head end bearing – Lower end seal - chrome plated stainless steel wear sleeve, water tight bellows type rubber seal and secondary grease seal – High efficiency v-belt drive assembly (one drive assembly per spiral) includes 20-HP TEFC motor and Dodge TA-II double reduction shaft mount reducer – Tapered discharge chute set at 45o angle to grade See Model 5044-32T Spec Sheet for additional information
STRUCTURAL SUPPORT – Steel 10” wide-flange support columns and 10” wideflange skid runners on each side – Broken down for shipment and match-marked for ease of assembly in the field
WATER SYSTEM – All fresh water plumbing to a single 8” inlet located near the tail end of the fine material washer – Fine material washer manifold includes a 4” butterfly valve, 4” swing check valve and pressure gauge – 1-1/2” chase water plumbing with gate valves – Screen manifold with flow control valves for each spray bar – Fourteen (14) spray bars with a total of one hundred ten (110) 7.0 gpm (@ 40 psi) spray nozzles and eighty-four (84) 15.0 gpm (@ 40 psi) spray nozzles – 4” connection on the screen manifold for the optional feed box
SCREEN CHUTES / FINES HOPPER – 3/16” A36 welded plate steel construction – Chutes allow for positioning of three (3) radial stackers under the chutes – Fines hopper transitions to the feed box of the 44” twin fine material washer
ACCESS – 36” wide access platform with 1-1/2” OD handrails and toeboards across the feed end and one side of the screen – 48” wide access platform with 1-1/2” OD handrails, and toeboards along drive side of the screen – Ladder access from grade which can be located on either side of the plant
PHYSICAL / OPERATING CHARACTERISTICS – Feed Material Size - Typically 6” minus – Capacity - Approximately 700 TPH (dependent on feed gradation and desired products) – Water Requirements - Up to 2,700 gpm (dependent on feed gradation and desired products) – Operating Dimensions Length 52’-8” overall Width 16’-8” Height 21’-11-1/4” without feed box / 25’-6-1/4” with feedbox – Loads Overall 125,000 lbs Note individual plant weights will vary dependent on options included